View unanswered posts | View active topics It is currently Sat Aug 19, 2017 10:58 am



Reply to topic  [ 5 posts ] 
 Single MAB ? 
Author Message

Joined: Wed Oct 23, 2013 8:01 am
Posts: 113
Do the tubes on the air bleed have to stick out past the casting? I was going the reduce them by first knocking them out 7 using 6-32 screws to size the bleed.


Tue Nov 17, 2015 6:54 pm
Profile
Site Admin

Joined: Fri Feb 08, 2013 2:37 pm
Posts: 1744
I would plug it and drill new bleeds in the locations of the dual bleed carbs, one on the top and one on the side. .046" seems to work well.


Tue Nov 17, 2015 8:18 pm
Profile

Joined: Wed Oct 23, 2013 8:01 am
Posts: 113
I'd like to do one each way just to see which one I liked better. I'm going to dig through my stash to see if I have any dual bleed carbs that are hot air or electric choke, preferably large primary.


Tue Nov 17, 2015 10:51 pm
Profile

Joined: Wed Oct 23, 2013 8:01 am
Posts: 113
Well damn I found 3, I guess I was hesitant to use any of them because 2 have front inlet & all 3 have non chevy throttle linkage.


Wed Nov 18, 2015 8:43 am
Profile

Joined: Wed Oct 23, 2013 8:01 am
Posts: 113
tuner wrote:
I would plug it and drill new bleeds in the locations of the dual bleed carbs, one on the top and one on the side. .046" seems to work well.

Will this keep the same or close to the same jet & rod?


Thu Nov 19, 2015 11:08 pm
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 5 posts ] 

Who is online

Users browsing this forum: No registered users and 1 guest


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software for PTF.