View unanswered posts | View active topics It is currently Thu Aug 17, 2017 7:49 am



Reply to topic  [ 14 posts ]  Go to page Previous  1, 2
 Carb Question: Emulsion package 
Author Message

Joined: Sat Aug 17, 2013 8:59 am
Posts: 130
These have small heads also look under Demon air bleeds, from SummitRacing.


part no. 200082


Thu May 25, 2017 7:57 pm
Profile

Joined: Sat Mar 16, 2013 7:58 am
Posts: 80
Update: I changed the e-bleeds to 1,3,5 are .028 ( ran out of blank 4-40 set screws. more on the way) 2 and 4 are blank. MAB is .026. Inter air bleed is .085. Inter jet taken from .038 to .028. Did not change anything to do with the idle or main jet. Put on a DataMaxx data recorder.Now found out that I have a lean spike at .25 seconds into the run. These are dual carbs that are not side ways but, sit at an angle to make them sit directly on top of the cylinders. Now I have to try to correct that lean spike.


Sat Jun 03, 2017 10:11 pm
Profile
Site Admin
User avatar

Joined: Fri Feb 08, 2013 5:50 pm
Posts: 2357
Can you sneak the float level up a little?


Sun Jun 04, 2017 9:14 am
Profile

Joined: Sat Mar 16, 2013 7:58 am
Posts: 80
Will give it a try. Racing in two weeks. Will give me time to drill 4-40 set screws ( that showed up while I was at the track yesterday) for e-bleeds.


Sun Jun 04, 2017 9:52 am
Profile
Display posts from previous:  Sort by  
Reply to topic   [ 14 posts ]  Go to page Previous  1, 2

Who is online

Users browsing this forum: No registered users and 2 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  
Powered by phpBB® Forum Software © phpBB Group
Designed by ST Software for PTF.